The emergence of pump truck lubricating agent has replaced the role of traditional cement mortar in lubricating pump truck pipe walls. Lubricant lubricating pump pipes mainly have the following characteristics: environmental protection and energy saving , save money, time and effort. Today, the editor takes a medium-sized commercial concrete station as an example. Based on an annual output of 300,000 cubic meters of concrete and a pump operation of 1,500 times a year, the transportation cost of the vehicle and the cost of mortar are calculated as 500 yuan each time. The maintenance cost in a year is as high as As much as 750,000, this is just a conservative estimate by the editor. The actual maintenance cost of most commercial concrete stations will be higher than this estimate. If pump truck lubricating agent is used instead of cement mortar lubricating agent, the usage cost is only a fraction of that of cement mortar lubricating agent. Therefore, the widespread use of lubricating agent is a trend in the future.
During the actual use of the lubricant, many workers came into contact with it for the first time. They did not know how to use it and did not use it well. In the end, they The finger points at the pipe moisturizer, saying that pipe moisturizer cannot replace cement mortar pipe moisturizer. Why does this happen? In the final analysis, it is a misunderstanding caused by people's inability to use it correctly. Today, the editor will explain the correct use of Yuanda pipe moisturizer. I will teach you the method and hope it will be helpful to the majority of workers.
First: When purchasing lubricant, be sure to look for pump truck lubricants produced by well-known brands from large manufacturers. Do not buy low-quality lubricants cheaply. The lubricating effect of low-quality lubricant is too poor and will not work at all.
Second: After each pouring, the pump pipe must be rinsed clean, and try to use a cleaning ball, especially the elbow of the ground pump, which is the easiest to deposit If you don't use a cleaning ball and just wash the stones with water, the water will not take away the stones at all. It will only wash away the cement and sand in the concrete. The stones will still remain in the elbow. If you wait until the next time the concrete is pumped, , these stones became a roadblock. After the lubricant dissolves, it becomes glue-like. It is difficult for the lubricant solution to take away the stones, and the pipe will not be opened and blocked. We have found out the cause of the problem. The key to solving the problem is the above The pump pipe must be flushed after a construction is completed.
Third: The materials used in moisturizers produced by large manufacturers are generally better. It is best to dissolve them for more than 5 minutes before the effect will be more obvious. If If someone tells you that it only takes one minute to dissolve, then it must be made of inferior materials with insufficient molecular weight, so it will dissolve quickly and the lubrication effect will be poor. The above three points are the key points for using pump truck lubricant well. As long as you master these three points, you will truly feel the money-saving, time-saving and labor-saving effect of lubricant!
</p
微信扫一扫打赏
