Toluene diisocyanate manufacturer Knowledge Air-entrained block plastering mortar

Air-entrained block plastering mortar

Air-entrained block plastering mortar

1. Product introduction:
Air-entrained block plastering mortar is mainly used to solve the problems that traditional cement mortar often occurs after plastering high water absorption base layer, such as poor adhesion, unstable quality, hollowing and cracking of the plaster layer, etc. and developed new building materials. This product has low plastic shrinkage and drying shrinkage, which reduces the early plastic shrinkage cracks of the mortar, improves the impermeability, frost resistance, and wear resistance of the mortar, thus inhibiting the generation and development of cracks, thereby achieving waterproofing and barrier properties. cracking, toughening, strengthening and other functions. It has good construction performance, easy operation, and will not cause bleeding and segregation.

2. Scope of application:
1. Suitable for aerated concrete blocks, lightweight boards, lime sand bricks, clay porous bricks, concrete hollow blocks, ceramsite bricks, etc. Plastering construction of interior and exterior walls with highly absorbent wall materials.
2. Plastering construction of reinforced concrete shear walls, beams, columns and slabs.
3. After the bottom plastering is completed, mesh cloth can be added for reinforcement when using surface waterproof plastering mortar.

3. Construction instructions:
1. Base layer treatment: Check that there are no hollows, oil stains, release agents, floating dust, loose holes, etc. on the surface of the base layer.
2. Ingredients: Calculate the required clean water according to the water-cement ratio of powder: water = 4:1. Slowly add the air-entrained block plastering mortar to the water and stir until uniform. According to the specific construction habits on site The water-cement ratio can be adjusted appropriately. Let it sit for 5-10 minutes and stir evenly before use.
3. Construction method: If plastering is done by hand, the thickness of each application should not exceed 10mm to ensure good bonding between the mortar and the base layer. When the thickness exceeds 15mm, it is recommended to plaster in stages. If mechanical spraying is used, use a long scraper immediately after spraying to remove excess material. After the mortar has initially set (about 1-2 hours, depending on the site), use a scraper to finish.

4. Reference dosage: The plastering thickness is 10mm, and the dosage is 10-12kg/m2.

V. Precautions:
1. The mixed aerated block plastering mortar should be used up within 2 hours. The dried mortar should be discarded and there should be no raw powder. . 2. During construction, smoothing, calendering, and roughening should be completed before final setting.
3. During plastering construction and the following three hours, the ambient temperature should not be lower than 5℃. Within 48 hours after the construction is completed, the minimum ambient temperature should be higher than 0℃. The air temperature and wall temperature during construction should be lower than negative. When the temperature is high, measures to keep warm should be taken.

6. Storage and transportation:
1. This product is non-toxic, odorless, pollution-free, environmentally friendly and energy-saving, and can be transported as general cargo.
2. Store in a cool and dry environment, avoid rain and moisture, and the shelf life is six months.
3. Packaging specifications: 50 kg/bag. </p

This article is from the Internet, does not represent the position of Toluene diisocyanate reproduced please specify the source.https://www.allhdi.com/archives/18166

author:

Previous article
Next article
Contact Us

Contact us

+86 - 152 2121 6908

Online consultation: QQ交谈

E-mail: sales@newtopchem.com

Working hours: Monday to Friday, 9:00-17:30, closed on holidays
Follow wechat
Scan wechat and follow us

Scan wechat and follow us

Back to top
Home
E-mail
Products
Search