1. Product introduction:
The waterproofing effect of cement-based penetrating crystalline waterproof coating comes from the various active chemical components it contains, which interact with the tiny rectangular structures in the concrete under the guidance of water. . With the help of the osmotic pressure of water, it enters the capillary zone of the concrete, and its various chemical agents mix and react to form crystals, which seal the capillary tubes and shrinkage cracks and drive away the water. This reaction can occur on either the front or back surface of the concrete structure.
2. Product characteristics:
1. Even if the surface is damaged, it can still maintain its waterproof and chemical resistance properties. No special protection is required when backfilling, tying steel bars or reinforcing mesh.
2. It can resist chemical corrosion and provide a variety of protection. Such as: seawater, corrosive groundwater, carbonic acid compounds, chlorides. 3. It can form a complete, durable and strong whole with concrete. Do not confuse coating or film products with other products.
3. The chemically active substances contained in it can penetrate into and seal the capillary zone inside the concrete and shrinkage cracks below 0.4 mm. Therefore, it can be used on the front surface or the back surface of concrete structures.
4. It is an environmentally friendly product, non-toxic and odorless, and can be used on wet or initially set concrete base surfaces.
5. 100% compatible with concrete, bricks and stone materials.
6. It can not only protect concrete and steel bars but also enhance the compressive strength of concrete.
3. Penetration crystallization series products:
CCCW concentrated type It has extremely strong chemical penetration and catalytic crystallization capabilities, and is suitable for waterproofing concrete structures and preventing surface corrosion from chemical substances.
CCCW Early strong type is suitable for special materials such as cracks, construction seams, reserved holes, and honeycomb hemp surfaces such as fissure of pipe roots, repairing concrete structures, and the use of early strength at low temperature is better at low temperature.
CCCW leak plugging type contains rapid coagulant, which blocks water and solidifies very quickly. It is used to plug cracks and leaks under pressure conditions.
4. Scope of application:
Used for any concrete or block structure that stores water or prevents water penetration. Applied to concrete structures that may or have been exposed to moisture or chemical attack. It permanently waterproofs and protects concrete structures. Its ability to be applied to the front or back surface of a structure enables it to solve most waterproofing problems.
5. The ratio of cement-based penetrating crystallized waterproof coating:
The ratio of material: water is 1:0.3. The reference dosage per square meter of the structural layer surface is: 1.2-1.5kg, and the coating thickness is 0.9mm. The required dosage is more than 1.5kg in basements, post-pouring zones, reservoirs, pile heads, and pile foundations. The amount required for each extension of the water section with serious leakage is 5-6kg.
6. Notes:
●All water used should meet drinking water standards. ●Please wear rubber gloves when mixing and applying. Please wear eye protection when spraying gunite and doing construction on your back.
7. Packaging and storage: This product is packed in round plastic barrels, 25 kg per barrel, and plastic-coated paper bags 10 kg/bag.
</p
微信扫一扫打赏
