1. Product introduction
Concrete pipe moistening agent (Pump Runtong) is a polymer material produced by our company's patented technology. Pipe moistening agent (pump runtong) can significantly improve the concrete pumping capacity, reduce pipeline friction and pipeline resistance, significantly extend the service life of pump pipes, completely replace pump mortar, reduce processes, shorten operation time, and has the characteristics of rust prevention, fast, and Convenience, environmental protection, money saving and other advantages.
2. Scope of application
Pipe lubricant (Pump Runtong) products are suitable for lubricating pumps in on-site pump pipes for pumping concrete and various dry mortars. It has good adaptability to various grades of concrete and completely replaces the pump mortar of various pump pipes. Pipe moistening agent (Pump Runtong) products can avoid pump clogging accidents of concrete pumps and on-site mortar pumps, reduce transportation vehicles, improve equipment utilization, and reduce the use costs of enterprises using ready-mixed concrete and ready-mixed dry mortar. Using lubricant products saves time, effort and worry, and is a new pumping construction technology.
3. How to use
Before pumping, first take the required amount of clean dissolved water and pour it into the container, and then add the pipe moistening agent (Pump Runtong) evenly and slowly , add while stirring until completely dissolved, then let stand for 3 minutes, stir again and use. When using a truck pump to pump concrete, slowly pour the prepared lubricant solution into the hopper along the inner wall of the pump truck hopper and fill it with the pump tube inlet. Then start slowly pouring concrete into the hopper and start adding water at the same time. Carry out concrete and ready-mixed mortar pumping operations. The method is the same when using a ground pump, but attention should be paid to appropriately adjusting the dosage of the product and dissolved water. When using a ground pump, the total length shall not exceed 100 meters. If you need to use a ground pump exceeding 100 meters, purchase a special pump for ground pumps from the company.
JH-RB pump lubrication general dosage preparation table
Delivery pump tube length Product dosage Dissolved water dosage
Below 65 meters 1 bag More than 30 kilograms
65 meters-100 meters 2 bags More than 60 kilograms
100-200 meters 3-4 bags 150 kilograms
4. Key points for product use
1. First, ensure that the pump pipes and connecting parts of the truck pump, ground pump, and mortar pump are sealed and have no leakage points;
2. After checking the pump pipes of the pump truck, flush the pump with clean water to ensure that there are no leaks in the pump pipes. Residues, debris and other blockages;
3. When pumping concrete, the pump lubrication solution should be discharged from the outside of the concrete formwork first, and remember not to pour it into the concrete structure;
4. After the concrete pump and ready-mixed mortar pump are pumped, the pump pipes and pump trucks should be flushed with clean water in time;
5. Protective glasses should be worn when using this product. If the product solution is accidentally sprayed into the eyes, rinse immediately with plenty of water.
5. Economic benefit analysis of using Pump Runtong
Using Pump Runtong product once can save about 230 yuan in pump mortar and transportation vehicle costs, based on an annual output of 200,000 cubic meters of concrete , 100,000 cubic meters of ready-mixed mortar, if the pump is started 2,600 times a year, it can save about 600,000 yuan a year.
6. Packaging and Storage
The tube moisturizing agent (Pump Runtong) product is packaged in degradable color laminate. Packaging specifications: 50 bags/box, 300g/bag. This product should be stored in a sun-proof, ventilated and dry place. Shelf life: three years.
</p
微信扫一扫打赏
