As a polymer material, pump truck lubricant has a strong lubrication effect and can completely replace traditional cement mortar lubricant, which can greatly save the waste of cement mortar. It can also save construction costs for construction units. Pump truck lubricant must be used scientifically and normally to achieve the desired effect of the lubricant, and it can reduce the impact on the construction quality and achieve twice the result with half the effort. Today, the editor takes this opportunity to teach you the correct way to use moisturizer. I hope it can be of some help to the majority of netizens.
First: Construction units and commercial concrete manufacturers must purchase qualified moisturizing agents produced by regular manufacturers when purchasing moisturizing agents. Nowadays, there are some small workshop-style merchants on the market that use inferior raw materials to produce inferior lubricants. Not only does the lubrication effect fail to meet the requirements, but more seriously, these inferior raw materials will corrode the pump truck parts and the steel in the building structure. In the early days of use, you will not notice much except that the lubrication effect is relatively poor. After using it for a period of time, you will find that the parts of the pump truck are rusty everywhere, which will accelerate the damage of the parts of the pump truck over time. , and at the same time, the same situation will occur with the steel bars in the building structure, which poses a huge safety hazard to the quality of the building.
Second: During the use of lubricant, the lubricant solution after lubricating the pipe must be discharged outside the formwork, and it cannot be poured directly into the structure. Among them, since most of the components of the moisturizing agent are water, if it is poured directly into the structure, it will change the water-cement ratio of the concrete and reduce the slump, which directly affects the strength of the concrete. The correct way to use it is to put the moisturizing agent solution that has been used to moisten the pipe outside the formwork, and observe with the naked eye whether the concrete is normal. Only when the concrete becomes normal can it be poured into the structure.
Third: Before the lubricant solution has completely evaporated, people must not step directly on the lubricant solution to avoid slipping and causing unnecessary safety accident.
The above three points are the correct ways to use pump truck lubricant. If used correctly, it can greatly improve work efficiency and save a lot of money for the construction unit. An expense. </p
微信扫一扫打赏
