JH aerated block masonry mortar agent Anhui aerated block masonry mortar agent manufacturer Bengbu masonry mortar agent where to find

1. Scope of application:
This product is a new and efficient inorganic plasticizer product, suitable for M5, M7.5, M10, M15, M20 building mortar, masonry aerated concrete blocks, and clay hollow bricks , concrete small hollow blocks, bottom ash mortar, aerated concrete leveling mortar, etc.

2. Main properties:
1. Good water retention, high bonding strength, small shrinkage, no hollowing, no bleeding, no caking, and freeze-thaw resistance.
2. The construction feels good, the compaction is good, the construction is simple and fast, saves labor and materials, no dust on the floor, and improves the construction efficiency.
3. This product is a new type of inorganic plasticized product, which is non-toxic, odorless, pollution-free, safe and environmentally friendly.
4. Implementation standards: JC/T164-2004, GB18588-2001.

3. Reference dosage: For every 100 kilograms of cement, add 15 kilograms of special mortar for air-entrained blocks. Mix and stir evenly before use. The mortar strength ratio remains unchanged during use.

IV. Construction method:
1. Add cement, sand, mortar agent and water to the container and mix thoroughly. Let it sit for 3-5 minutes, then stir it a little before use. When using, adjust the consistency to 65-90mm. Adding sequence: add the ingredients first and stir well, then add water and stir.
2. The grouting should be even and flat (the effect of using a toothed scraper is better). The length of the grouting should be the length of one block, and it can be placed as it is laid; the blocks should be set up once, and the mortar will lose its plasticity. Adjust beforehand; the blocks on the upper wall should not be moved at will or impacted. If correction is needed, the mortar should be re-paved. The fullness of the gray joints must meet the specification requirements, and the vertical joints should be filled and scraped flat. It is strictly forbidden to use water for grouting. Blind seams, translucent seams and stuffing of seams with sundries are strictly prohibited. If the requirements are not met, masonry mortar must be used to fill and joint the joints, otherwise the plastering layer will easily become hollow in the future.
3. Apply the mixed mortar evenly on the blocks, and control the mortar thickness to about 10-20mm.
4. Place the blocks on the corresponding wall, adjust the position and compact them.
5. The remaining matters should comply with the relevant construction specifications for masonry projects.

5. Precautions:
1. When the air temperature and wall temperature are lower than negative temperature during construction, heating measures should be taken, and early-strength antifreeze can be added for use.
2. Do not mix with other materials such as sugar, alcohol, microfoaming agent, lime king, etc.
3. Any quoted water that meets national standards can be directly used for mixing mortar; when other mixing water is used, it must be inspected in accordance with the "Concrete Mixing Water Standard" (JGJ163) and can only be used after passing the standard. Mix in dry mortar. </p